# A webhook was turned off

Why a lead box gets disabled, what the email means, and how to get it running again.

## What happened

Every event a lead box sends is retried up to 18 times over about four days when your endpoint does not answer with a `2xx`. When the last retry fails, Mav turns the lead box off and emails your account's admins and managers, with Mav support copied. The subject starts with **Mav turned off a lead box** and names the webhook URL, email address or Slack channel. Events that happen while it is off are not queued; they are gone.

## Find the cause

Check your endpoint for the days before the email:

- **Timeouts.** Mav waits 3 seconds to connect and 3 seconds for a reply. Reply `200` first and do the work afterwards.
- **Redirects.** A `301` or `302` counts as a failure. Point the lead box at the final URL.
- **Auth.** If your endpoint expects a token, set **Auth** to Bearer on the lead box and enter it.
- **A changed URL** after a deploy or a vendor migration.

## Get it running again

Fix the endpoint, then open the lead box under **Settings › Lead Boxes**, check its settings and click **Save changes**. Saving turns it back on. Use **Send test** to confirm a `2xx` before you rely on it.

## Check before it happens

**Send test** on any lead box posts one sample event right away and shows the result as a toast, so you can verify a new endpoint in seconds.